Eberle — Pls 514 Download Manual |top|
Manuals and technical documentation for the legacy Eberle PLS 514 PLC are available through industrial archives, including a 371-page document on Scribd and specific component information via Classic Automation. The system, commonly programmed using EDOPS 2 Plus, requires specialized knowledge of its octal/12-bit addressing and specific interface cables for communication. For detailed hardware specifications and available documentation, visit Classic Automation. Eberle PLC PLS 514 Programming software - PLCTalk.net
Industrial Archives: Websites specializing in "legacy" or "obsolete" PLC manuals often host the PDF for the 514 series. eberle pls 514 download manual
EDOPS2 / EDOPS2 Plus Software: This is the proprietary environment required to program the PLS 500 series. Users often seek this legacy software on PLCTalk forums or through specialized legacy archives. Note that this software historically required a physical dongle or password for full operation. Technical Specifications & Setup Manuals and technical documentation for the legacy Eberle
that matches the PLS 514 specifications for a modern system? Supply Voltage: 230V AC / 24V AC (Check
- Supply Voltage: 230V AC / 24V AC (Check your specific model suffix – PLS 514.01 vs PLS 514.11)
- Output: 1 x changeover relay (NO/NC)
- Switching Capacity: 8A / 250V AC (resistive), 4A (inductive)
- Channels: 1 channel (Single circuit control)
- Memory: 56 memory locations (Programs)
- Resolution: 1 minute
- Switching Cycles: 56 ON/OFF events per week
- Backup: Lithium battery (Type CR2032) – retains program for ~5 years without mains power.
- Operating Temperature: -10°C to +55°C
Because the PLS 514 is obsolete, documentation and programming tools are primarily found through community archives and legacy support channels:
Manuals and technical documentation for the legacy Eberle PLS 514 PLC are available through industrial archives, including a 371-page document on Scribd and specific component information via Classic Automation. The system, commonly programmed using EDOPS 2 Plus, requires specialized knowledge of its octal/12-bit addressing and specific interface cables for communication. For detailed hardware specifications and available documentation, visit Classic Automation. Eberle PLC PLS 514 Programming software - PLCTalk.net
Industrial Archives: Websites specializing in "legacy" or "obsolete" PLC manuals often host the PDF for the 514 series.
EDOPS2 / EDOPS2 Plus Software: This is the proprietary environment required to program the PLS 500 series. Users often seek this legacy software on PLCTalk forums or through specialized legacy archives. Note that this software historically required a physical dongle or password for full operation. Technical Specifications & Setup
that matches the PLS 514 specifications for a modern system?
- Supply Voltage: 230V AC / 24V AC (Check your specific model suffix – PLS 514.01 vs PLS 514.11)
- Output: 1 x changeover relay (NO/NC)
- Switching Capacity: 8A / 250V AC (resistive), 4A (inductive)
- Channels: 1 channel (Single circuit control)
- Memory: 56 memory locations (Programs)
- Resolution: 1 minute
- Switching Cycles: 56 ON/OFF events per week
- Backup: Lithium battery (Type CR2032) – retains program for ~5 years without mains power.
- Operating Temperature: -10°C to +55°C
Because the PLS 514 is obsolete, documentation and programming tools are primarily found through community archives and legacy support channels:
Ждите идёт загрузка...
