Advance Design Tutorial ((full)) | Graitec

Concrete Projects: The My First Project: Concrete Edition is a comprehensive 12-lesson series. It covers everything from defining columns and walls to final reinforcement of footings and slabs.

Design Mode: Where specific material design (Steel, Concrete, Timber) takes place. Results Mode: For post-processing and report generation. 2. The Modeling Phase graitec advance design tutorial

1. Draw a steel beam (Select Steel beam > IPE section).
2. Apply loads as above.
3. Go to Design > Steel > Verify.
4. Look at the "Utilization ratio." If it is 0.45, the beam is too strong (heavy).
5. Click Design > Optimize.
6. Set target utilization to 0.85.
7. AD will cycle through IPE sections (IPE 200, 220, 240) until it finds the smallest beam that works.
8. Result: It might switch from IPE300 to IPE270, saving you 15% in steel cost.

1. Installation: Download and install the software from the Graitec website. Make sure to follow the installation instructions carefully.
2. Launch the software: Launch Graiter Advance Design and create a new project.
3. Set up the project: Define the project settings, including the units, material properties, and load cases.

Advance Design Training Videos For Steel & Concrete Projects Concrete Projects : The My First Project: Concrete

• Tutorial 1: Interface & grid creation
• Tutorial 2: Material & section assignments
• Tutorial 3: Load application (wind, snow, live)
• Tutorial 4: Load combinations (automatic & manual)
• Tutorial 5: Result interpretation & deflection checks
  This mirrors real engineering tasks.

The Pilot: This is the primary navigation tool. It organizes your project into three main modes: Draw a steel beam (Select Steel beam > IPE section )