Shimadzu Gc-2010 Service Manual | Direct Link
The GC-2010 system typically includes a gas chromatograph, an injection port, a column oven, and high-sensitivity detectors like the FID. Environmental Requirements: Requires a temperature between and relative humidity of for optimal performance. Space Clearances: Minimum of behind the instrument and on the left side for ventilation and maintenance access.
Introduction
Power Handling: Always use a power supply with an earth leakage breaker. If the cable is hard-wired to a distribution board, ensure the board switch is off before maintenance. Routine Maintenance & Consumables shimadzu gc-2010 service manual
The Shimadzu GC-2010 is a gas chromatograph designed for analytical and research applications. This service manual provides guidelines for maintenance, troubleshooting, and repair of the instrument. The GC-2010 system typically includes a gas chromatograph,
Chapter 4: Pneumatics (APC/EPC System)
- This is the heart of the GC-2010. Detailed exploded views of the Advanced Pressure Control (APC) units.
- Step-by-step procedures for leak checking using the built-in diagnostic mode.
- Pressure sensor calibration routines (requires a digital pressure gauge).
- Split/Splitless inlet flow path cleaning and graphite seal replacement.
Part 3: Common Procedures Every GC-2010 User Should Perform (Using the Manual)
Even if you are not a certified service engineer, the service manual empowers you to perform essential maintenance safely. Here are three critical procedures excerpted from the manual’s practical sections: This is the heart of the GC-2010
- Verify carrier gas flow rates
- Check for contamination
When working with the GC-2010, always follow these safety guidelines:
- FID (Flame Ionization Detector): Instructions for cleaning the collector assembly, replacing the igniter wire, and adjusting the jet height using a specialized jig (part of the manual’s appendix).
- ECD (Electron Capture Detector): Safety interlocks, purge gas requirements, and the procedure for checking the make-up gas line for oxygen contamination.
- TCD (Thermal Conductivity Detector): Balancing the filaments and verifying the bridge voltage.